Thursday, February 19, 2009

Clutch Pushrod Receiver

Special thanks to my workmate Mikhail who went home last night and spun me a clutch pushrod receiver per Wilhelm's measurements and my DXF file.

All it needs is test fit... then figure a way to fasten it to the pressure plate (hopefully it will interference fit into the square hole)... put a ball bearing in the middle... figure a way to fasten that so the ball doesn't fall out, when the pushrod is pulled out the back (set screw, or center punch?)Harden it... then put it in with some grease.

1 comment:

  1. With friends like Mikhail, why would want or need a lathe ;-) TT